How do I pause seconds command?

The value -1 causes the computer to wait indefinitely for a keystroke (like the PAUSE command) /nobreak Ignore user key strokes. Timeout will pause command execution for a number of seconds, after which it continues without requiring a user keystroke.

How do I add a pause in CMD?

Execution of a batch script can also be paused by pressing CTRL-S (or the Pause|Break key) on the keyboard, this also works for pausing a single command such as a long DIR /s listing. Pressing any key will resume the operation.

What is Pause command in CMD?

The pause command is used within a computer batch file. It allows the computer to pause the currently running batch file until the user presses any key.

How do I add a pause to a batch file?

You can insert the pause command before a section of the batch file that you might not want to process. When pause suspends processing of the batch program, you can press CTRL+C and then press Y to stop the batch program.

Is there a wait command in CMD?

You can use timeout command to wait for command prompt or batch script for the specified amount of time. The time is defined in Seconds. The above commands will break the timeout process on pressing any key. You can use /NOBREAK ignore key presses and wait for the specified time.

What is Windows REM command?

Rem (abbreviation of remark) is a command (internal) found inside the Windows Command Processor Command Prompt, that allows for inclusion of comments inside batch programs. Comments are supported by most Programming languages usually via special syntax that is associated to them.

What does the pause CMD command do in Windows?

Pause – CMD Commands The Pause command suspends the processing of a batch program and displays the following prompt: Press any key to continue… This is beneficial in case you do not wish to complete the batch program or perhaps you need to give the user a chance to insert a new disk into the drive before continuing the batch.

Is there a way to pause the terminal?

For instance, using the following on the command prompt will pause the terminal for 10 seconds unless you press a key: timeout /t 10. Whereas this command will pause the terminal for 30 seconds whether you press a key or not: timeout /t 30 /nobreak.

How to use timeout delay in seconds CMD?

Delay execution for a few seconds or minutes, for use within a batch file. Syntax TIMEOUT delay[/nobreak] Key delayDelay in seconds (between -1 and 100000) to wait before continuing. The value -1 causes the computer to wait indefinitely for a keystroke (like the PAUSE command) /nobreak Ignore user key strokes.

Is there a way to pause a batch file?

If you are writing a batch file and you don’t want to continue until somebody presses a key, you can do it really easy with the timeout command. For instance, using the following on the command prompt will pause the terminal for 10 seconds unless you press a key: timeout /t 10.