Which technology reduces the size of a broadcast domain?
Which switching technology reduces the size of a broadcast domain? Explanation: Virtual LANs break up broadcast domains in layer 2 switched internetworks.
What device limits the broadcast domain?
Routers
Routers and other higher-layer devices form boundaries between broadcast domains. The notion of broadcast domain should be contrasted with that of collision domain, which would be all nodes on the same set of inter-connected repeaters, divided by switches and learning bridges.
What devices create a broadcast domain?
TCP/IP Protocols and Devices Layer 2 LAN switches logically create broadcast domains based on configuration of the switch. The configuration tells the LAN switch what to do with a broadcast received on a port in terms of what other ports should receive it (or if it should even be flooded to all other ports).
Which command used to remove the trunk mode of a port?
Table 3-7 Resetting Configures Values on Trunk Lines
Enter global configuration mode. | S1# configure terminal |
---|---|
Configure the port in access mode. | S1(config-if)# switchport mode access |
Optionally, remove the trunk mode if it was entered. | S1(config-if)# no switchport trunk encapsulation [dot1q | isl] |
How can I reduce the size of my broadcast domain?
A lot of broadcast traffic might impact your network performance so reducing the size of the broadcast domain is something to consider. Routers do not forward broadcast traffic, they break broadcast domains. VLANs on switches also allow you to break broadcast domains.
How many devices can affect a broadcast domain?
Older operating systems also used a lot of broadcast traffic for their applications. Broadcast domains with 1-1000 devices are common nowadays. Still, a single device that sends a LOT of broadcast traffic does affect the entire broadcast domain so it’s a good idea to limit the size of your broadcast domains.
How to reduce the number of devices that receive broadcast traffic?
A small publishing company has a network design such that when a broadcast is sent on the LAN, 200 devices receive the transmitted broadcast. How can the network administrator reduce the number of devices that receive broadcast traffic? Add more switches so that fewer devices are on a particular switch.
Can a Ethernet switch broadcast to a broadcast domain?
Switches will also broadcast Ethernet frames if they haven’t learned the destination MAC address yet. A broadcast domain is a collection of network devices that receive broadcast traffic from each other. For example, here’s our network with three switches again: Broadcast traffic is not very efficient.