Mell What multiport setting do I use to drain pool?
You would use the ‘Waste’ setting to drain or partially drain your pool or you may use it when vacuuming if there is a lot of dirt and debris on the bottom of your pool.
Should both valves be open on pool pump?
For the cleaner to operate at maximum efficiency, only the skimmer and cleaner valves should be open. No other valves should be open. So it is either main drain+skimmer or cleaner+skimmer. Never main drain+skimmer+cleaner all open at the same time.
What does the waste setting on my pool filter?
WASTE/DRAIN: Another filter bypass setting, but this setting sends the water out of the waste pipe (hose), instead of returning it to the pool. This setting is used to lower pool water level or to vacuum to waste, which is best when vacuuming algae or heavy amounts of dusty, silty debris.
What setting should my pool pump be on to vacuum?
For routine vacuuming, the filter valve is left in the normal “Filter” position. This directs dirty vacuum water through the pool filter to remove the contaminants, then conveys filtered water through return lines back to the pool. The “Filter” setting is used for light to moderate levels of pool sediment.
How do I know if my Jandy valve is open?
On a two port Jandy valve, the valve has two closed positions and one open position. On the left, the valve is closed because the diverter is blocking the flow of water through the port. In the center, the diverter is blocking nothing, so the valve is open and water can flow through it.
Where is the main drain valve on a pool?
The main drains are usually located on the lowest point in the pool, so the entire pool surface slants toward them. Most of the dirt and debris that sinks exits the pool through these drains.
How do I know if my pool drain is working?
You can test if the drain is working correctly by placing a tennis ball to the skimmer hole. The ball should be large enough to cover the hole and not get sucked into the system. You can easily see if the ball gets sucked to the skimmer hole, and that is enough proof that the main drain is working correctly.
How to set valves for an in-ground swimming pool?
Opening the main drain and then closing the cleaner valve. So it is either main drain+skimmer or cleaner+skimmer . Never main drain+skimmer+cleaner all open at the same time.
Is it OK to open the main drain valve on a pool?
Should the Main Drain Valve Be Open? No, not if you are using a suction type of cleaner. The purpose of a pool main drain is to pull water from the bottom of the pool through the pump and filtration system. With a suction cleaner operating, it is already doing exactly what the main drain does, which is to pull water from the bottom of the pool.
What’s the best way to drain an inground pool?
1. Open Up The Main Drain This guide’s method will deal with how to drain an inground pool with main drain. That said, you must first separate the main drain from the skimmer valve. From there, you need to close the skimmer valve and open up the main drain.
When to use the valve positions on a pool filter?
It is the pool filter valve positions setting that your filter will spend most of its life on. Mostly it will be used when the pool pump runs on your timer to keep the water in the pool clean. The filter setting is also the one you will use the most when vacuuming your pool.