How do you remove a power steering pump pulley without a puller?

How do you remove a power steering pump pulley without a puller?

The easiest and most common method to remove power steering pulley bolt is by hitting it with an impact tool. However, another method is by using a wrench to unbolt it. You simply have to turn it counterclockwise to remove and then clockwise to tighten it back.

What tool do I need to remove power steering pump?

Using an impact wrench or regular socket and ratchet, remove the bolts holding the power steering pump onto the bracket or the engine block. Usually there are two or three bolts that need to be removed. Once this has been completed, remove the old pump and take it to a workbench for the next step.

Is it hard to replace power steering pump?

The pump replacement is easy to do once a few tricks are recognized. For example, do not attempt pump replacement without locating a power steering pump pulley puller. Using a standard pulley puller may make the pulley out of round — not a good thing!

When should power steering pump be replaced?

How to Tell If a Power Steering Pump Is Bad: 5 Warning Signs You Need to Know About

  1. Your Car Makes a Whining Noise Any Time You Turn the Wheel.
  2. Your Car’s Steering Wheel Is Slow to Respond.
  3. Your Car’s Steering Wheel Is Stiff.
  4. Your Car Makes Squealing Noises When You Turn the Key in the Ignition.

How do you change power steering pump on Dodge Caravan?

Take the pump and pulley assembly over the aluminum bracket and out of the engine. Install the new pump on its bracket and torque the front mounting bolts to 40 foot-pounds. Install and torque the rear mounting bolt and spacer to 40 foot-pounds. Reinstall the pressure and supply hoses.

How do you remove a power steering pump?

Remove the rear support bracket, which is mounted behind the power-steering pump, with the appropriate socket. Remove the two mounting bolts that secure the pump to the alternator and belt-tensioner bracket. Remove the pump and pulley assembly from the vehicle. Remove the pulley with the pulley remover tool. Install the pulley on the new pump.

How do you remove power steering fluid from a car?

Lift the belt off of the pulleys. Open the power-steering pump reservoir, and using the turkey baster or other siphoning device, remove the power-steering fluid from the reservoir. Discard the fluid in an appropriate manner. Raise the vehicle with the floor jack and support it with jack stands.

How do you drain a power steering return line?

Slide the drain pan under the power-steering pump. Loosen the hose clamp on the power steering return line with the screwdriver. Allow the line to drain into the drain pan. Remove the accessory belt splash shield with the appropriate socket.