Can you change cylinder on revolver?

In a word, no. One must change the cylinder. And then the barrel must match the caliber. There are revolvers that do came with other cylinders that are made to match that particular gun.

Can 38 special revolvers shoot 357?

No; . 357 Magnum was specifically designed so it cannot be fired from handguns chambered in . 38 Special, but you can shoot .

What is the chamber of a revolver called?

cylinder
In firearms, the cylinder is the cylindrical, rotating part of a revolver containing multiple chambers, each of which is capable of holding a single cartridge.

Is a 357 magnum more powerful than a 38 special?

The comparisons we’ve given have the same bullet sizes, making it clear that the . 357 Magnum is more powerful. 38 Special Super-X with a 158-grain bullet has a muzzle energy of 200 feet per second, while their . 357 Magnum Super-X with a 125-grain bullet has a muzzle energy of 1,370 feet per second.

Can a.357 be cleaned with A.38?

Also works very well at cleaning bores and getting your forcing cone clean. As a bonus, this is a 9mm size, it works for .38 / .357 / 9mm just like brushes / bore snakes, and one tool for multiple guns is always the way to go.

What to do with fouled chambers on a 357?

Luckily, it’s not permanent. Even if cleaned normally after shooting .38 Spl, you still may need to go a bit further to remove this fouling. You could use a slightly oversized brass brush (for instance, a .40 S&W brush in a .357 Cylinder) soaked in solvent and just have at it for a while. A serious while.

What kind of ammunition is a 357 Magnum?

Smith & Wesson introduced this cartridge for its heavy-frame revolver. Ammunition was developed by Winchester in cooperation with Smith & Wesson. Using a lengthened and strengthened version of the .38 Special case, the .357 Magnum was rapidly accepted by hunters and law enforcement.

What to use to clean A.38 SPL cylinder?

Even if cleaned normally after shooting .38 Spl, you still may need to go a bit further to remove this fouling. You could use a slightly oversized brass brush (for instance, a .40 S&W brush in a .357 Cylinder) soaked in solvent and just have at it for a while. A serious while. It takes A LOT of effort to remove this fouling this way.