Mell How do you reset the computer on a 2000 Chevy Impala?
Hello! Disconnecting one of the battery cables for 30 seconds will erase any fault information stored in computer memory, and reset it.
How do you reset the computer on a Chevy Impala?
Remove the negative battery cable and set it aside, then turn the headlight switch to the ON position to drain the ECM of any residual power. Wait at least 10 minutes, and then turn it back off, re-hook up the negative battery cable, and go ahead and properly start Your Impala; the computer should be reset.
How do you reset the computer on a 2001 Chevy Impala?
put the key in and turn to the accessory point,do not start the car. Once you get to “acc” on the ignition press down 3 times on the gas pedal but NOT fast,sort of slowly. Turn it off then start the car,it should reset and the light goes off if not.. repeat it.
How do you reset the computer on a 2002 Chevy Impala?
2002 Chevy Impala? to reset it just disconnect the battery negative cable for 5 minutes Take it to your local auto store and they can check the car computer and tell you why it’s on for free.
Will unhooking battery reset the computer?
While disconnecting the battery is the most common method of resetting your computer, it’s not always the best way. That’s because disconnecting the car battery causes your computer to lose its memory. So, things like your preset radio stations, shift points, and your car’s ideal fuel/air mixture are forgotten.
How do you reset the computer on a 2003 Chevy Impala?
Turn the ignition to ACC or ON, with the engine OFF. Turn the radio OFF. Press and hold the DISP button until SETTINGS is displayed. Press the SEEK up or down arrows until TIRE MON is displayed.
How do you reset the computer on a 2008 Chevy Impala?
Locate the erase button, and push it down. It can be found on Your scan tool. Once the codes have cleared from the computer, let the motor run for around 8 to 12 minutes. Check again, and the computer should be fully reset.
How do you reset the computer on a Chevy?
To do this, you need a special tool called an OBD scan tool, which has the ability to reset the vehicle’s diagnostic computer, clear all error codes, and shut off the warning and check-engine lights. Locate the OBD port to the left of the fuse panel. You may need to remove the fuse panel cover to access this on some Chevy vehicles.
How do you reset the computer on a Chevy Malibu?
Unplug the computerized scan tool from the port. Turn on the engine and observe the instrument panel to make sure all warning lights have shut off. The computer is now reset. Turn the key in the ignition to the “Key on/Engine off” position. Locate the diagnostic link connector in you Chevy Malibu.
How to reset the computer on a 2001 Monte Carlo?
How to Reset the Computer on a 2001 Monte Carlo Put the key into the ignition and turn it to the “on” position, but do not start the engine. Plug the computerized scan tool into the diagnostic port under the dash. You can buy a computerized scan tool from your local auto parts retailer.
How do you reprogram a Chevy PCM car?
Click on the “Pass-Thru” option under diagnostic tool, “Reprogram ECU” under select programming process, and “Vehicle” under ECU location. Click the “Next” button in the lower-right hand section of the window to proceed. Enter the VIN number in the VIN text box in the “Determine Vehicle” window, and click on “Apply” next to the text box.