Is it safe to use reloads?

Reloading ammo is safe when you start low and work your way up. Never start at your reloading manual’s maximum load. This can be dangerous, and many times isn’t necessary. The safest way to develop new loads is to start at the minimum load and work your way up.

Is it legal to reload bullets?

California law generally prohibits people from owning, possessing, or having custody or control of ammunition or reloaded ammunition if they fall into any of the categories of people who are ineligible to purchase or possess firearms under state law.

Is it dangerous to reload bullets?

Any mishandling of firearms or ammo can be dangerous. But when the rules are adhered to, reloading ammunition is no more dangerous than operating a kitchen stove. Not that the factory ammunition produced today is poorly made; in fact, factory ammo is better than it’s ever been.

How much does a reloading setup cost?

$250 – $500 will probably cover your startup and it depends on what kind of a press and powder scale you want primarily. You can spend a lot more if you get into progressive presses – probably $ 1500 total for higher end equipment.

Why are reloads bad?

When reloading, or specifically, handloading (i.e., reloading “by hand” at home, and not “factory remanufactured” reloads), the reloader can make mistakes either due to equipment failure, lapse of attention, or by mistake or incompetence, and three conditions can result in an overpressure condition that can explode a …

Are 9mm reloads reliable?

It’s accurate and reliable. Need to be careful with plated bullets because not all are created equal. Plating thickness can vary from 0.003″ up to 0.012″. Jacketed bullets range from about 0.017″ to 0.032″.

Do you need an FFL to make bullets?

You do need a Federal Firearms License (FFL) to manufacture and sell cast bullets.” (A) The term “ammunition” means ammunition or cartridge cases, primers, bullets, or propellent powder designed for use in any firearm.

What can go wrong when reloading?

5 Common Reloading Mistakes and How to Avoid Them

Powder Charge Errors. The first common mistake is loading the wrong powder or too much powder into the cartridge.
Bad Casing. The next common mistake is using a bad casing.
Primer Seating.
Projectile Seating.
Crimping Mistakes.

How many times can you reload a 9mm case?

Reload it until it shows signs of wear, usually mouth splits. No reason they should not be loaded 5-6 times, perhaps a lot more. Mostly, I lose semi-auto brass well before they fail. I have loaded 9mm brass as many times at a dozen and still no neck splits or primers falling out.

Do you have to follow instructions when reloading?

Since reloading is an activity that requires precision, you should follow instructions exactly. Many people have had accidents due to a failure to follow instructions. One of the most common examples of this is trying to “hotrod” a load to get greater velocity.

Is it worth it to reload a gun?

The financial value is not the only means of measuring the worth of handloading ammunition. Performance and precision must never be overlooked. There’s a definite investment when it comes to purchasing reloading tools, not to mention the cost of powder, primers, cases and projectiles, or shotshells and shot.

Is it safe to reload ammo in a dangerous situation?

Almost every dangerous situation that you could experience reloading ammunition can be traced directly back to those three things. So if you are an intelligent human being who knows what they are doing and are paying attention, your chances of reloading safely are pretty good. Related: Is Reloading Ammo Worth It?

Why is it important to reload ammo cartridges?

For some cost isn’t an issue and the value of reloading is found in other factors. Accuracy, consistency, reliability and the quality control inherent in reloading are priceless. It also opens the door to utilizing cartridges not embraced by ammo makers. Additionally, when there is an ammo drought reloading gives you peace of mind.