Can you shoot the Smith and Wesson 610 without moon clips?

Can you shoot the Smith and Wesson 610 without moon clips?

Yes, the ridge in the chamber is for using 10mm cartridges without the moon clips. However, you will have to punch them out with a rod as the extractor star will not contact the rimless cartridge. Just use the moon clips, it’s much easier.

What frame is the sw 610?

The Model 610 is a six-shot, double-action revolver chambered for the 10mm Auto cartridge. The 610 was manufactured by Smith & Wesson on the N-frame, similar to the Smith & Wesson Model 29 in .

Does a 10mm revolver make sense?

The 10mm is a well-respected cartridge, and can be loaded to a wide range of power levels and using a wider range of bullet profiles than would feed and function in an autoloader. The drawback of 10mm ammunition is that it is usually hard to find and expensive.

What is a 10 mm revolver?

nomenclature: 10 mm Auto, official SAAMI nomenclature: 10mm Automatic) is a powerful semi-automatic pistol cartridge first developed by U.S. Marine Jeff Cooper and introduced in 1983 with the Bren Ten pistol. Its design was adopted and later produced by ammunition manufacturer FFV Norma AB of Åmotfors, Sweden.

Can you shoot a revolver without moon clips?

Are moon clips necessary? Moon clips are actually required for most revolvers chambered for semi-automatic calibers like 9mm, . 40 S&W and . With rimmed cartridges, moon clips are not required, but may be used to increase speed and efficiency in loading.

Are moon clips necessary?

Moon clips are actually required for most revolvers chambered for semi-automatic calibers like 9mm, . 40 S&W and . 45 ACP. With rimmed cartridges, moon clips are not required, but may be used to increase speed and efficiency in loading.

Is the Smith and Wesson Model 610 still in production?

Smith & Wesson introduced the Model 610 revolver, then discontinued it when sales were slower than expected. Then they reintroduced it when enough people expressed interest. The cycle continued for years, and even when the Model 610 has been in production, it has remained relatively rare.

Where is the firing pin on the Smith and Wesson 610?

The firing pin is a part of the frame’s internals rather than positioned on the hammer, and the 610 includes the much-­maligned internal lock that allows users to render the gun useless with the turn of a special key.

When did the Smith and Wesson 622vr come out?

S&W 622VR: Same as the regular 622 but has a ventilated rib (VR) cut in the frame above the barrel. Made only in 1996 in limited numbers. Some made in Houlton Maine have a painted silver frame instead of anodized. S&W 2205: A blue steel variant introduced in the 1992 shot show.

What’s the difference between s and W 622 and S & W 2206?

S&W 622: Same alloy frame and barrel length options as the 422 but in a silver colored frame with a stainless steel slide. S&W 622VR: Same as the regular 622 but has a ventilated rib (VR) cut in the frame above the barrel. Made only in 1996 in limited numbers. S&W 2206: Both the frame and the slide are stainless steel.