How do you clear ABS warning light?

Press down on the brake pedal with your hand. You will hear a click at which point you will release the brake. Push and release the brake pedal eight times within three seconds. The ABS light will stop flashing, stay illuminated for one second then will flash four times to indicate you have cleared the light.

Can AutoZone reset ABS light?

It Might Be the ABS Unfortunately, the only way to check whether or not the problem is with the ABS is to go and get the codes of your car read. AutoZone can scan your codes as part of our Fix Finder service, or you can do it yourself if you already have a scan tool.

How do I fix my ABS light always on?

Firstly, you should check your brake fluid reservoir to ensure that the levels aren’t too low, as the ABS warning light can be activated if the levels of brake fluid have dropped. If this is clearly an issue, you can top the brake fluid up yourself, which should cause the ABS light to go off.

How do you reset ABS control module?

Plug the computerized scan tool into it and power on the scan tool. Navigate to the “ABS” menu on the computerized scan tool by pushing the down arrow button. Select “Clear all codes.” Power off the computerized scan tool and disconnect it from the DLC connector. Turn on the vehicle and verify that the ABS module is no longer lit.

How do you reset ABS warning light?

Locate the DIC control panel on the dashboard in front of the driver’s seat under the speedometer. Keep pushing and releasing the “Set” button on the DIC control panel until “ABS” is shown. Hold the “Set” button for about 5 seconds to reset the light and turn it off.

What causes the ABS warning light to come on?

The two reasons for an ABS light to come on are to test the function of the bulb or to warn the driver that some type of fault has occurred in the anti-lock brake system. Some of the common reasons for an ABS light to come on include: Standard bulb check. Low fluid.

What is ABS control module?

The ABS control module is a microprocessor that runs diagnostic checks of a vehicle’s antilock braking system and processes information from wheel-speed sensors and the hydraulic brake system to determine when to release braking pressure at a wheel that’s about to lock up and start skidding. Antilock brakes have been available…