How do you reset the computer on a Dodge Ram 1500?

How do you reset the computer on a Dodge Ram 1500?

To reset the computer in your RAM 1500, take the following steps:

  1. Identify your battery’s negative cable.
  2. Disconnect the negative cable from the battery.
  3. Wait 20 minutes so that all systems have shut down.
  4. Reconnect the negative cable.

How do I get my Dodge Ram out of limp mode?

To get the Dodge Ram 1500 out of limp mode you need to stop and shift to park. Turn the car off and wait 30 seconds, now turn it back on and it will be out of limp mode.

How do you reset the computer on a 2013 Dodge Ram 1500?

Disconnect the battery cables, put the battery on a charger on it for about ten or fifteen minutes, and then reconnect. Start truck, let idle till it reaches operating temperature, turn it off and count to 15, and restart. That’s an easy way to “reset”.

How do you reset a Dodge Ram computer?

Unlatch the hood by pulling the hood release handle near the driver’s side foot well. Depress the handle underneath the Ram’s grille and open the hood. Disconnect the negative terminal cable from the battery with a combination wrench. Set the negative terminal cable aside and wait 20 minutes.

How to reset the Check Engine light on a Dodge Ram?

Dodge Ram: How to Reset PCM and Check Engine Light. 1 Step 1 – Remove the PCM fuse. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch 2 Step 2 – Reset the PCM. 3 Step 3 – Re-install the PCM fuse. 4 Related Discussions.

Why do I need to Reset my PCM on my Dodge Ram?

There are other reasons why you would need to reset the PCM, such as after the installation of aftermarket components that require a PCM reset so the truck can fully adjust to new components. The reset procedure in your Dodge Ram is as easy as they come.

Why is my computer not working on my Dodge truck?

Ironically, only several codes pertain to the actual engine in your truck. Many of the codes can indicate a problem with the transmission, emissions control system and even the fuel system. To erase the code and get the light to go off, you will need to reset the computer. This will involve cutting the power to the computer.