What is sending and receiving voltage?

What is sending and receiving voltage?

Generally the terms “sending end voltage” and “receiving end voltage” are related to transmission and distribution the voltage at the terminal of generator is termed as “sending end voltage” while the voltage at the other end (distribution centre , industry etc.)

How do you calculate sending voltage?

The Sending End Voltage Using Power Factor(STL) formula is defined as the voltage we have given to the system is calculated using sending_end_voltage = sqrt((((Receiving end voltage*cos(Receiving end theta))+(Receiving end current*Resistance))^2)+(((Receiving end voltage*sin(Receiving end theta))+(Receiving end current …

What is the role of cut off voltage?

The term Cut-off Voltage is activated voltage level at which the charge controller ( a voltage and/or current regulator) disconnects the load from the battery. The battery’s cut-off voltage is determined by the manufacturer, so that consumers can achieve the maximum capacity of their batteries.

What is the difference between sending and receiving end voltage?

Generally the terms “sending end voltage” and “receiving end voltage” are related to transmission and distribution the voltage at the terminal of generator is termed as “sending end voltage” while the voltage at the other end (distribution centre , industry etc.) Is termed as “receiving end voltage”.

How is voltage regulation of a transmission line defined?

Voltage regulation of transmission line is defined as the ratio of difference between sending and receiving end voltage to receiving end voltage of a transmission line between conditions of no load and full load. It is also expressed in percentage. Where, V s is the sending end voltage per phase and V R is the receiving end voltage per phase.

How is the current related to the voltage?

Due to the larger value of reactive power (Q) the line current lags behinds the voltage and the voltage regulation is considered by a reduction in voltage extent. In transporting a larger quantity of active power (P) to loads, a current is frequently in phase with the voltage.

How is voltage calculated at the receiver point?

In this equation, the (V nl) is the voltage calculated at the receiver point when there is no load device at that point. The complete short line approximation is an open circuitry in this situation, and there is a current move in the open circuitry. so (I = 0 A) and the loss of voltage at the line can be fined by the ohm’s law.