How do you take the radio out of a Chevy Impala?

How do you take the radio out of a Chevy Impala?

Pull the top right hand corner of the lower dash panel away from the dashboard. Continue to pull this away working your way to the left until the lower dash panel drops to the floor. Remove the two seven-millimeter bolt screws on either side of the radio. Pull the radio out of the dashboard.

Does a 2003 Chevy Impala have an aux?

Super Moderator. There is no Aux input for this generation of Impala.

Do I need to disconnect battery before removing head unit?

It’s recommended procedure to disconnect your car battery before making any electrical changes. This is a good safety measure because an accidental short could take place while making changes.

How do you use the aux in a Chevy Impala?

How to Use Chevy AUX Input

1. Turn your key to the “On” position to power on your Chevy’s electronics.
2. Attach one end of the cable into the audio jack on your radio face plate (usually located on the lower-right side of the radio).

Does the 2004 Chevy Impala have an aux?

Where is the heater core on a 2002 Chevy Impala?

Replacing your Chevy Impala’s heater core is no easy task. There are several parts you must carefully remove or reposition to disconnect the core from the heating, ventilating and air conditioning (HVAC) module. This module and the core are located behind the car’s floor ducts.

How do you unlock the radio on a Chevy?

How to Unlock a Chevy Radio Step 1: Start the vehicle and turn on the radio. Step 2: Press and hold preset numbers 2 and 3 until a three digit code appears on the radio display. Step 3: Press the AM/FM button. Step 4: Call the Chevy Radio Code phone line at 1-800-537-5140.

How can I get my GM radio out of my car?

Phoning in for Your Radio Retrieval Code Dial 1-800-537-5140 to connect with GM’s toll-free radio hotline. Enter the numbers “106010” when prompted for a dealer access code. Punch in your vehicle’s 6-digit radio identification number when instructed. Write down the 4-digit radio retrieval code as it’s recited to you.

What to do if your GMC radio says INOP?

If radio display reads “INOP” while the vehicle is on, too many incorrect radio codes have been entered. To remove “INOP” from your display and unlock your radio, you must leave the key in the On position for one hour. Once you’ve retrieved your radio unlock code, write it down for future use.

How to reset an anti-theft radio on a Chevy?

Press the “AM/FM” button until “SEC” appears on the radio display. Press the “ON” button on the radio. The radio is now reset. Press the “Minute” and “Hour” buttons slowly until the security code matches. Going too fast may cause you to skip over the correct numbers of the security code. Store your radio security code in a safe place.