How to clean a Smith and Wesson Model 686 revolver?

How to clean a Smith and Wesson Model 686 revolver?

I’ll illustrate the disassembly and cleaning procedures with a Smith & Wesson Model 686, which is built on the company’s L-frame. As always, make sure your revolver is unloaded. Follow the four golden rules of gun safety when checking: keeping your finger off the trigger, aim the gun in a safe direction and open the cylinder.

Where is the stirrup on a Smith and Wesson 686?

On models like the pictured Smith & Wesson 686, the main spring stirrup will be hooked onto the hammer but not attached. In those cases, be sure you pay attention to the direction in which the mainspring stirrup is mounted to the hammer, since it can easily fall off during removal.

What does hammer block do on Smith and Wesson 686?

Open the cylinder and slide it forward to remove it. Certain newer revolvers — typically DA models such as the pictured Smith & Wesson 686 — have a hammer block. The hammer block is used as an internal safety mechanism and can fall out once the side plate is removed. Lift the hammer block free from the gun and set it aside with the other parts.

How to take care of the S & W revolver?

Disassembly and Care of the S&W Revolver ~ Learn how to from a Factory Trained Armorer! If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.

How do you fire a Smith and Wesson revolver?

• Never touch the trigger until you are ready to fire. • To fire the handgun, pull the trigger fully to the rear. The ham – mer will move rearward and then fall forward to fire the revolver. After firing, you must allow the trigger to move for- ward fully before you can fire another shot.

When did Smith and Wesson stop using bug screws?

The uppermost side plate screw — the “bug screw” — was discontinued around 1956 and after approximately 1961, the screw in front of the trigger guard was also eliminated. Today, most Smith & Wesson revolvers are made with three screws, although there are some being produced with the “classic” five-screw design.

How many screws are in a Smith and Wesson revolver?

Today, most Smith & Wesson revolvers are made with three screws, although there are some being produced with the “classic” five-screw design. As you remove the screws, lay them on your mat in specific order to ensure they are replaced in the correct location.