How do I plug in speakers to my computer?

How do I plug in speakers to my computer?

Use the following steps to connect a pair of front desktop speakers to the computer:

  1. Position one speaker on each side of the computer monitor.
  2. Connect the audio cable to the green Speaker Out port on the back of the computer.
  3. Plug the speaker AC adapter into the electrical outlet and turn on the speakers.

Can you connect speakers to a desktop computer?

You can easily connect a set of headphones, though not every PC lets you use both the headphones on the front of the console and speakers on the back. USB speakers: You can plug USB speakers or headphones into any USB port on the computer….Connect Speakers to Your Windows PC.

Color Connection
Red Microphone
White S/PDIF input

How do I use headphones and speakers at the same time?

In case you’re wondering, can you also play music through your headphones and speakers at the same time using your Android or iOS device? Yes, but there aren’t any built-in settings for Android or iOS that let you do this. The easiest way is to use an audio splitter to send the sound to two or more devices.

Should I connect speakers to PC or monitor?

TL;DR : Plug them into the BACK of the PC. Your PC is better equipped to handle sound than your monitor, Also, monitors accept signals from the PC and output them to speakers. There is not often a bypass built into monitors that allow signals to come from PC, bypass the monitor and go to the power amps.

Where do you connect speakers to motherboard?

The internal speaker connects in the same area as your front case panel connectors. You should see 4 open pins on the backside of where you connected the Power & Reset switches from your case. It plugs into those pins and if you look real close on the motherboard, it says speaker.

How do I use two audio outputs?

1. Enable Stereo Mix

  1. Right-click the Speakers icon on the system tray and select Sounds.
  2. Select the Playback tab shown in the snapshot directly below.
  3. Then select your primary speakers audio playback device and click Set as default.
  4. Select the Recording tab shown directly below.

How do I connect external speakers to my desktop?

Step 1: Ensure that the computer is turned off. Step 2: Plug the speakers into the power socket. Step 3: Locate the 3.5mm jack connected to the cable at the back of the speakers. You’ll use this plug to attach them to your computer tower.

When I plug in my speakers There is no sound?

Fix 3: Configure the audio settings Improper audio settings in your computer can also cause your speakers plugged in but no sound. So you should check the following audio settings to fix your sound problem. Select your audio device and click Set Default. Ensure there’s a green check next to your audio device.

How do I connect the speakers to my computer?

Follow these step-by-step instructions to attach speakers to your computer Step 1: Ensure that the computer is turned off. Step 2: Plug the speakers into the power socket. Step 3: Locate the 3.5mm jack connected to the cable at the back of the speakers. Step 4: On the back of the computer tower are a number of small, round, coloured-coded sockets.

How do I install new speakers on my computer?

Installing Computer Speakers Determine the speaker setup. Find the speaker connectors on your computer. Understand the color codes. Place your speakers. Connect the satellites and center channel to the subwoofer (if necessary). Plug the speakers into the appropriate jacks. Test the speakers.

Where do speakers to computers usually plug in?

Rear speaker jacks: The standard PC setup is to plug a set of stereo speakers into the audio output jacks on the I/O panel , located on the back of the typical PC. S/PDIF: High-end audio systems might employ the Sony/Phillips Digital Interconnect Format.

How do you plug a microphone into a PC?

Plug the headphone connector on the headset to the green-colored jack on the back of the desktop PC or into the headphone jack on the right or left side of the laptop or netbook. 2. Connect the microphone to the pink-colored jack on the back of the desktop computer or into the mic jack on the right or left side of the laptop or netbook.