How do I advertise a network in RIP?

Only three steps are required:

enabling RIP by using the router rip global configuration command.
instructing the router to use RIPv2 by typing the version 2 command.
telling RIP which networks to advertise by using one or more network commands.

What is VLAN on router?

A virtual LAN (VLAN) is a local area network that maps devices on a basis other than geographic location, for example, by department, type of user, or primary application. Traffic that flows between different VLANs must go through a router, just as if the VLANs are on two separate LANs.

How do I check my router for RIPs?

To display route information from the Routing Information Protocol (RIP) topology table, use the show ip rip route command in any mode.

How to configure routing information protocol : RIPv2?

Using the Cisco IOS, the command to enable RIP routing protocol is router rip. The version command is used to specify which RIP version to use (either 1 or 2). If the version command is omitted then the router defaults to sending RIPv1 but can receive both RIPv1 and RIPv2.

How to configure router router RIP v2?

Configuring RIP routing protocol consists of three basic steps: Enabling RIP routing protocol on the router. Specifying the RIP version to run. Configuring the network addresses to be included in routing updates or specifying the interfaces to participate in routing updates.

What do network administrators need to know about RIPv2?

RIPv2 is a valuable tool that provides quick and simple IP routing, and it should be in every network administrator’s toolbox. This week, I want to review some common things every network administrator needs to know about RIPv2. We’ll start with RIP fundamentals and then discuss how to configure this protocol.

How does auto summarization work in RIP v2?

According to the classful, network specified, the subnets of that network are automatically identified and participate in the routing update. By default routing updates are summarized at network boundaries. In RIPv2 this auto summarization behavior can be turned off using the no auto-summary command.