How do you get a stuck BB out of a BB gun?

If it is in the barrel of the weapon then using a metal thin line or something small but agile that can fit through the barrel to push the BB back into the loading chamber (or reverse) should work. Make sure the magazine is out so that the BB just falls right out.

What should I use to clean my Red Ryder BB gun?

Cleaning and Maintaining your Red Ryder. Unless shooting your BB gun it should always be on safety. When cleaning the gun it should be unloaded as well. It is always better to be over-cautious when using firearms. For the blued areas of my Red Ryder BB Gun it is recommended to use a cloth with gun oil.

What do you need to repair a BB gun?

First remove the gun stock by removing the screws that hold it in place. Next, there is a metal piece that sticks out of the top of the barrel just behind the rear sight. This piece holds the spring-loaded plunger in place and provides the rear stop that the spring is compressed against when the gun is cocked.

Why is my BB gun not firing properly?

The problem is with the piston assembly that produces the puff of air pressure that propells the BB out of the gun. The air chamber is contained between two seals. These are shown here in the compressed position as they would be after fireing the gun. The red arrow points to the stationairy seal (toward the forward end of the gun).

Is there a way to unjam a gun?

Click here to jump to that post. Yes mate, find a gun cleaning kit, to maintain your firearms. The author of this thread has indicated that this post answers the original topic. My gun jammed a while ago i unjammed it but i couldnt put a new mag…

How to clear a cartridge Jam in a pistol?

Clearing a simple jam 1 Keep the pistol pointed in a safe direction at all times. 2 Make sure it is a jam, and not that you had a misfire or are just out of ammunition. Open the action and look to see… 3 Remove the magazine. 4 Rack the slide a few times until the jammed round flies out. 5 Insert a magazine and rack the slide. More …

What’s the best way to get a round out of a handgun?

Use a small, sharp tool to pry the round out of the chamber if the action is shallow enough to allow this method. With the action locked open, use a metal pick, or a very small flat bladed screw driver, to pry the edge of the cartridge out of the chamber.