What shortcut command can be used to enter the privileged EXEC mode?

The shortcut keys used to go directly from global configuration mode to privileged exec mode is CTRL+Z.

Which command is used to go to the privilege mode?

Enable
To get into Privileged Mode we enter the “Enable” command from User Exec Mode. If set, the router will prompt you for a password. Once in Privileged Mode, you will notice the prompt changes from “>” to a “#” to indicate that we are now in Privileged Mode.

Which command is used to get you to privileged EXEC mode Dell?

To access Privilege Exec mode, open a new console session with the user name “admin.” However, if you are currently in Normal Exec mode, you can also access Privilege Exec mode by entering the enable command (followed by the privileged level password if so configured).

What is the shortcut key for exit configuration mode?

There are four ways to exit configuration mode in Cisco and go back to privileged EXEC mode: Ctrl-Z, Ctrl-C, and the “end” and “exit” commands.

How do I change to privileged EXEC mode?

Exit or Access Next Mode (For the switch) Change terminal settings, perform basic tasks, and list system information. Enter the logout command. To enter privileged EXEC mode, enter the enable command. Privileged EXEC From user EXEC mode, enter the enable command.

What is encrypted with the enable secret command?

What is encrypted with the enable secret command? the privileged executive mode password.

What can you do in privileged EXEC mode?

Privileged EXEC level can be password protected to allow only authorized users the ability to configure or manage the router. From privileged EXEC level, you can access all the command modes.

What will happen if you press Control Z in CLI mode of the router?

Pressing Ctrl-Z or entering the end command will always take you back to EXEC mode regardless of which configuration mode or configuration submode you are in. Ends the current configuration session and returns to privileged EXEC mode.

What is enable secret 9?

Type 9. this mean the password will be encrypted when router store it in Run/Start Files using scrypt as the hashing algorithm. starting from IOS 15.3(3) Example : R1(config)#ena algorithm-type scrypt secret cisco.

How to enter privileged exec from user exec mode?

Privileged EXEC From user EXEC mode, enter the enablecommand. Switch#To exit to user EXEC mode, enter the disablecommand. To enter global configuration mode, enter the configurecommand. Global configuration From privileged EXEC mode, enter the configurecommand.

How to exit from privileged exec mode in Cisco?

Switch#To exit to user EXEC mode, enter the disablecommand. To enter global configuration mode, enter the configurecommand. Global configuration From privileged EXEC mode, enter the configurecommand. Switch(config)#To exit to privileged EXEC mode, enter the exitor endcommand, or press Ctrl-Z.

How to exit to global configuration mode in Cisco?

To exit to global configuration mode, enter the exitcommand. Config-vlan In global configuration mode, enter the vlanvlan-idcommand. Switch(config-vlan)#To exit to global configuration mode, enter the exitcommand. To return to privileged EXEC mode, enter the endcommand, or press Ctrl-Z.

How to set SVI in privileged exec mode?

Return to privileged EXEC mode from user EXEC mode. S1#Note: The password will not show up on the screen when entering. Enter global configuration mode to set the SVI IP address to allow remote switch management. Restrict console port access. The default configuration is to allow all console connections with no password needed.