What is the correct timing on a Chevy 350?

What is the correct timing on a Chevy 350?

The timing can vary between 2 and 12 degrees BTDC, the recommended spark plugs are different and even the plug gaps vary. In most cases starting out with 12 degrees of initial advance is about right.

How do you set the timing on a Chevy 305?

To adjust the timing, set the timing an additional 2 degrees before top-dead-center. Drive the car after each adjustment. When the car clatters upon acceleration, set the timing back 2 degrees. Reattach the hose on the vacuum advance, and disconnect the timing light after adjusting the timing.

What’s the ignition timing on a Chevy 350?

350’s Similar Specs The 350’s timing specifications are almost identical to the other small blocks. However, the ignition timing for the 255-horsepower version with manual transmission is at Top Dead Center and 4 degrees BTDC with automatics.

What should the timing be on a Chevy 454?

The initial timing should be 4 degrees before top dead center (BTDC). If the mark is adjacent to a higher number BTDC, the distributor must be rotated clockwise to bring it down to 4 degrees. If the number is lower or after top dead center (ATDC), turn the distributor counterclockwise.

How to timing a small block 350 Chevy?

Remove the the small tube which leads to your dist. from this small round shaped can beside the Dist and plug it with a screw or anything else. Readjust the idle speed (800) if necessary and set timing to at least 10� btdc. For to check if mechanical advance already comes in give a little throttle while looking for the timing.

How to set the timing on a Chevy?

Of course, use a timing light to properly set the timing once the engine is running. This method can be used to start an engine that has some sort of after market digital fuel injection system as well. It is recommended to set a 10 degree advance offset for the Chevy HEI 8-pin system.