How do you pull a slide out of a Smith and Wesson?

You then use a finger from your other hand to push on the slide stop pin as far as you can into the indent: When you have pushed it as far as you can from the other side, grab hold of the slide stop and pull it the remainder of the way out: Using both hands pull the slide from the frame, careful not to pop the recoil spring assembly as you do.

How to disassemble and reassemble Smith and Wesson 422?

The following instructions outline the process steps to disassemble and reassemble the Smith & Wesson 422/622/2206/2213/2214 series of 22LR pistols. The pistol used to develop these instructions was a 2206TGT; there may be slight variations in the process for other models.

How do you remove a hammer from a Smith and Wesson?

Using both hands pull the slide from the frame, careful not to pop the recoil spring assembly as you do. It is under pressure. Hold the spring assembly and slide firmly as you remove. ** (The hammer will drop as you pull the slide off)

How to disassemble a Smith and Wesson 9mm 5904?

Pull the slide back and lock it. Verify that no rounds of ammunition are in the chamber or the magazine well. Pull the slide further back until the slide stop notch on the right side of the slide lines up with the slide stop. Grasp the slide and frame securely in one hand.

How do you know if a Smith and Wesson is unloaded?

Of course – ALWAYS make sure the weapon is UNLOADED!!! First remove the magazine: Then clear the chamber and visually inspect to make sure it is empty: On the right side of the frame you will see an indent with a knob in the center. This is the back side of the slide stop. This is what you use to push out the slide stop:

Where is the indent on a Smith and Wesson 5906?

On the right side of the frame you will see an indent with a knob in the center. This is the back side of the slide stop. This is what you use to push out the slide stop: You push back on the slide to line up the slide stop on the frame with the notch on the slide:

How to disassemble a Smith and Wesson Sigma pistol?

Gently pull the bottom of the magazine if it does not drop out of the gun on its own. Grasp the slide and pull it back until it locks open to clear any remaining rounds. If there is a round in the chamber, it should pop out when the slide is pulled back.

Can a barrel be removed from a Smith and Wesson revolver?

Removing a barrel from a revolver is tricky. If you aren’t careful with how you hold the frame, it can crack, bend or break. Furthermore, most gunsmiths report the newer Smith and Wesson revolvers will often break when a barrel is removed so it is important to proceed with caution.

What’s the model number of a Smith and Wesson?

The 4500 series is for .45 ACP, 4000 series for .40 S&W, and 1000 series for 10mm. So, looking at the first two digits of a four-digit model number from a 3rd gen pistol, we can know the caliber, and if it’s a 9mm, we might also know the frame size.

How to get Smith and Wesson owner’s manual?

Please contact our customer support representatives for the most up to date information at 1-800-331-0852 Ext. 2904 8:00 a.m. to 8:00 p.m. Eastern Standard Time, Monday – Friday