What metric is used for RIP choose four?

RIP (Routing Information Protocol) uses hop count as the metric.

What metric is used by RIP and ripv2?

The routing metric used by RIP to evaluate routes is hop count. A hop count of 1 indicates a directly connected network, a hop count of 2 indicates that the packet will hit two routers before reaching the target network and so on.

How do you convert metric to RIP?

To add an additional value to the incoming IP Routing Information Protocol (RIP) route metric for an interface, use the ip rip metric-offset command. To return the metric to its default value, use the no form of this command.

How is hop count used in RIP?

RIP uses a hop count, which, as we described earlier, is the number of routers the packet will have to cross to reach the destination network. Each pass over a router increases the hop count by one hop. RIP has a maximum of 15 hops when routing packets to a remote network.

What is hop in RIP?

The RIP hop count The routing metric used by RIP counts the number of routers that need to be passed to reach a destination IP network. The hop count 0 denotes a network that is directly connected to the router. 16 hops denote a network that is unreachable, according to the RIP hop limit.

What are the drawbacks of RIP?

Disadvantages of RIP

Bandwidth utilization in RIP is very high as it broadcasts its updates every 30 seconds.
RIP supports only 15 hop count so a maximum of 16 routers can be configured in RIP.
Here the convergence rate is slow. It means that when any link goes down it takes a lot of time to choose alternate routes.

What is RIP version?

Routing Information Protocol (RIP) is the oldest and most used routing protocol today. There are two versions of RIP: v1 and v2. Version 1 is the most-deployed version, since it is compatible with all RIP-capable devices.

What is Rip networking?

Short for Routing Information Protocol, RIP is a routing protocol (RFC 1058) utilized by computers and other network devices (e.g., routers). It is used to broadcast known addresses for networking devices to learn available routes.

What is a rip computer?

RIP may refer to any of the following: 1. Short for Raster Image Processor or Raster Image Process, RIP is the process of converting a vector image into a raster image. 2. Short for Routing Information Protocol , RIP is a routing protocol (RFC 1058) utilized by computers and other network devices (e.g. routers).