How is the modelling of the knuckle joint done?

The modelling of the knuckle joint is done using 3D software. Here we will be using CATIA V5 for modelling. This joint permits angular misalignment of the rods and may take compressive load if it is guided. These joints are used for different types of connections e.g. tie rods, tension links in bridge structure.

How is the eye of the knuckle joint secured?

In knuckle joint one end of the rod is made into an eye and end of the other is formed into a fork with an eye in each of the fork leg. The knuckle pin passes through both the eye hole and fork holes and may be secured by means of a collar and taper pin or split pin.

When do you need to use a knuckle joint?

A knuckle joint is a mechanical joint used to connect two rods that are under a tensile load when there is a requirement of a small amount of flexibility, or angular moment is necessary. There is always an axial or linear line of action of load.

How are knuckle joints used in circuit breakers?

In large circuit breakers they are subjected intermittently to high impulsive loads transmitted to large scale linkages. The paper reports on design of a knuckle joint. The modelling of a knuckle joint is performed by using CATIA V5 R20 package The knuckle joint takes compressive loads often, thus there is a need for quality design tools.

What kind of software is used for knuckle joint assembly?

CATIA v5 software is used to modeling this object. Veerapandian.K MECHANICAL ENGINEERING. DIAGRAM PARTS WITH DIMENSIONS (KNUCKLE JOINT Veerapandian.K MECHANICAL ENGINEERING. WORKING STEPS AIM To create the knuckle joint assembly as a 3D solid model using CATIA V5 software. HARDWARE REQUIRED 1. CPU with pentium IV processor. 2.

How big is a cotter and knuckle joint?

5. 89 Keys, Cotter and Knuckle Joints5.5 COTTER AND COTTER JOINT A cotter is a metallic strip of uniform thickness but tapers in width. The taper may be very small like 1 : 100 but may be as large as 1 : 30. The cotter passes through slots made in two coaxial parts and thus prevent the relative motion between them.

Is the knuckle joint part of the auto card?

This knuckle joint is a part of my auto card project i have edited lots of shapes some are approximately value in diagram Show more… Knuckle joint Detail parts in 2D . DWG file Knuckle joint Detail parts in 2D . DWG file /

What do I need to make a knuckle joint?

To create the knuckle joint assembly as a 3D solid model using CATIA V5 software. HARDWARE REQUIRED 1. CPU with pentium IV processor. 2. A colour monitor with highest 32 bit colour display and with screen resolution 1024 by 768 pixels. 3. A scroll mouse. SOFTWARE REQUIRED 1. Windows XP operating system 2. CATIA V5 WORKING STEP: